mlbjerseys123

Accelerometer, the sensor can be used as ON / OFF switch. When the shoe does not move,

the accelerometer, there is no report on the pace - it stops sending data. In the case

of the output of the accelerometer, the sensor eventually go to sleep. However, when a

player put his shoes on, take a few steps, the sensor generates an electrical pulse,

and the sensor recovery operations. The sensor also has a physical switch that can

shut down equipment; units remain closed, until someone presses the switch again. This

preserves battery life (1000 hours of battery can not be replaced), when it was run on

a regular basis or run in different shoes.

 commonly known as the end of a PU or EVA, PU replica of a mold die is now no more

than 20,000, as long as about 1000 per pair, number 10 at most 10,000, but the PU raw

materials, expensive, wear, intolerance dissolved environmental protection in the end!

EVA, mold a little expensive, probably between 3000-6000, the second sub-time foam

with foam, not environmentally friendly, but very light, very wearable! Cushion with

PU or EVA are generally high in the piece in the mold, the production will have a good

cushion, according to the specified location into the PU or EVA mold by heat, dissolve

the PU and EVA, and then cooling, air will be connected with body!

commonly known as the general is on the end of TPU, are generally made of plastic,

air-cushion is made from raw materials through the TPU pellets! Produced after the

formation of mold, by measuring the volume of the inflatable! Injection molding

machine what price I think many people should know! Nike's most expensive I have also

seen inside the 400,000 or so!